Skip to main content

The Lifecycle of a Pipeline

  1. The user creates a new pipeline using CREATE PIPELINE.

  2. The user starts the pipeline using START PIPELINE.


    Steps 3 to 8 refer to a batch, which is subset of data that the pipeline extracts from its data source. These steps comprise one batch operation, which will succeed or fail completely. If any step fails, the batch operation rolls back.

  3. The pipeline extracts a batch from its data source. The pipeline's offsets are updated to reflect the current position in the data source.

  4. The pipeline optionally shapes (modifies) the batch, using one of three methods.

  5. If the pipeline is able to successfully process the batch, the pipeline loads the batch into one or more SingleStore tables.

  6. If an error occurs while a batch b is running, then b will fail and b 's transaction rolls back. Then b is retried at most pipelines_max_retries_per_batch_partition times. If all of the retries are unsuccessful and pipelines_stop_on_error is set to ON, the pipeline stops. Otherwise, the pipeline continues and processes a new batch nb ,which processes the same files or objects that b attempted to process, excluding any files or objects that may have caused the error.

    For more information, see View and Handle Pipeline Errors.

  7. The pipeline updates the FILE_STATE column in the information_schema.PIPELINES_FILES table, as follows:

    • Files and objects in the batch that the pipeline processed successfully are marked as Loaded.

    • Files and objects in the batch that the pipeline did not process successfully, after all retries are unsuccessful (as described in step 6), are marked as Skipped.

    A file or object that is marked as Loaded or Skipped will not be processed again by the pipeline, unless ALTER PIPELINE ... DROP FILE ... is run.

    The pipeline does not delete files nor objects from the data source.

  8. The pipeline checks if the data source contains new data. If it does, the pipeline processes another batch immediately by running steps 3 to 7 again. If the data source does not contain more data, the pipeline waits for BATCH_INTERVAL milliseconds (which is specified in the CREATE PIPELINE statement) before checking the data source for new data. If the pipeline finds new data at this point, the pipeline runs steps 3 to 7 again.


The user can stop a running pipeline using STOP PIPELINE. If this command is executed while a batch operation is executing, the batch operation completes before the pipeline stops.

During a pipeline's lifecycle, the pipeline updates the pipelines tables in the information schema, at different times. Other than the update of the information_schema.PIPELINES_FILES table mentioned in step 7, all of the other updates are not discussed here.